Chimney Advice · Macclesfield

Stone Chimneys in Hill Rain: Where the Water Sits

Water on a stone stack is not spread evenly. It collects in a handful of places, and knowing where they are makes a wet face much easier to read.

★ 5.0 from 74 Google reviews
✓ Repointing, flaunching, leadwork & pots
✓ Fully insured
✓ Free written quotations
✓ Chester, Cheshire & Wirral
Home › Chimney Repairs › Chimney Repairs Macclesfield › Stone Chimneys in Hill Rain: Where the Water Sits
The short version
  • Rain runs to horizontal surfaces, and stone stacks have more of them than brick ones.
  • Copings, ledges and the top of the wall are the first places to check.
  • Open beds under stones take water in sideways when rain is wind-driven.
  • A wall top with no fall or drip keeps the whole stack damp from above.
  • Stone slate roofs mean the stack is reached by scaffold, never by ladder.

Rain does not land evenly, it travels

When rain hits a chimney stack in open country it rarely falls straight down. It arrives at an angle, strikes the windward face, and runs down it until something stops it. Stone stacks give it plenty to stop on. Every projecting stone, every change of thickness and every joint that has gone back from the face is a place where a film of water can pause, collect and be drawn into the wall.

This is why the same stack can be dry on one side and dark on the other for days. The dry side may well be sound; the dark side is where the work is. It is also why a pattern is more useful than a single stain. A damp band at one height, a wet patch under one stone, a run down one corner: each points to a particular detail, not to general old age.

The stone itself is rarely the problem. Gritstone sheds water well and dries out reasonably quickly when it is exposed to air. The trouble starts where water gets into the wall and cannot easily leave again, which means in the joints, under the stones and behind the faces.

Ledges, set-offs and the shoulders of the stack

Many stone stacks are wider at the bottom than the top, and the change of size is made with a set-off: a sloping or stepped shoulder where the wall steps in. In theory the slope throws water outward. In practice, if the surface has settled, lost its fall or been patched with something that does not match, water sits on it and finds its way into the stack below.

Smaller ledges matter too. A stone that projects a few centimetres, a course that is thicker than the one beneath it, or a lintel-like stone across a recess will each gather water on its top surface. If the joint beneath has opened, that water goes straight in. Binoculars from the garden will show you which of these have a clear dry top and which have a dark, damp one.

Moss on a horizontal surface is a reliable marker. It does not grow where water leaves quickly. A cushion of moss on a ledge tells you that the surface has been holding moisture for a long time, and the joint below it deserves a closer look.

The head of the stack: copings, slabs and the wall top

The head takes more water than any other part of the stack, because everything above the roof line is open to the sky. Many stone stacks in this part of the world are finished with a dressed slab or a run of coping, weathered to a fall, with the flue openings cut through it. The joints between those pieces, and the bed beneath them, are the weak points. If those joints open, rain goes straight down into the core of the wall, where it can sit for a long time.

A coping with no drip is a smaller but related problem. Without a groove or an overhang on the underside, water runs round the edge of the slab and back along the underside to the wall below. You can often see this as a darker stripe on the face just under the coping. A projecting edge with a proper throating, even a simple one, breaks that path and keeps the face of the stack drier.

Where a stack has a mortar flaunching instead, the principle is the same: the surface must fall away from the pots, and the edge must overhang the stonework enough to shed water clear. Our guide to Chimney Pots, Cowls and Bird Guards: Which Do You Actually Need? covers what sits on top, and the question of whether a stack has a flaunching at all is one worth settling before anyone quotes for re-forming it.

Open beds, the rubble core and what you can check

Stone is laid on beds of mortar, and in a stack taking driven rain from the hills, the beds on the windward side are the first to wash out. Once there is a gap under a stone, water enters sideways, runs into the rubble core between the two faces, and stays there. A stack in that state may look fairly respectable from a distance and still be saturated inside.

From the garden, look for the signs described in our guide to What to Look For on a Chimney From the Ground: shadow lines at the joints, grit on the flags or in the gutter, and a wall that stays dark long after its neighbours have dried. In the loft, a broad dark band across the full width of the masonry points to a wet core rather than a leak from one side.

None of this requires a visit to the roof, and none of it should be tried from a ladder. If you are in or near chimney repairs in Macclesfield and a face stays wet for days, a few photographs from different angles are often enough for us to say whether it is worth a closer look. Where the roof is stone slate, the stack is reached from scaffold in any case, because the slates cannot be walked on.

Reading it all together from the ground

Put these together and a stack becomes easier to read. A dark band under a coping suggests a worn drip. Moss on a ledge suggests a surface that has lost its fall. Shadow at the beds on one face suggests driven rain has washed the mortar out. Each tells you where a repair is likely to be needed and, just as usefully, where it probably is not.

That matters when you compare quotations. A scheme that treats the whole stack the same way, with no reference to where the water actually sits, deserves a question or two. The best work targets the head, the set-offs, the joints on the exposed face and the junction with the roof, and leaves sound stone alone.

Wet weather will show you more than a dry day, so it is worth looking when the rain has just stopped, from a safe spot on the ground. Note which parts dry first and which stay dark, take a couple of photographs, and keep them. They make a description over the phone much more useful, and they give a baseline to compare against later.

Not sure what you are looking at? Describe it and we will tell you what it is likely to be — 07464 259566, WhatsApp, or Evensbuddy@yahoo.com. If water is coming in now, please call rather than email.
FAQs

Common Questions

Which side of a stone stack gets wettest?
Usually the side facing the prevailing wind, though that depends on what shelters it. Look at where the dark patches and moss are. They will show you far more reliably than guessing from the compass, because they reflect what the weather has actually been doing to that particular stack over a long time.
Do copings really need a drip on the underside?
They are far better with one. A groove or an overhang under the edge makes water fall clear instead of running back to the wall. Many old copings have lost theirs through weathering, and restoring or adding a simple throating is a modest part of repairing the head.
Is moss on a stone stack always a problem?
Not always. A light covering on a sheltered face is mostly cosmetic. Thick moss on a ledge, coping or top bed is more telling, because it means water is being held there. It is a pointer to the detail underneath, not something to scrape off without looking at what lies beneath.
Can a wet stone stack dry out by itself?
A sound one will, given some dry weather and air. A stack with open beds or a failed head will keep refilling faster than it dries, especially on the exposed side. If a face stays dark for days after the rest of the house has dried, that is the signal to have it looked at.
More Advice

Other Chimney Guides

More from the Macclesfield chimney series, then the wider guides.

Where We Work

Chimney Repairs Across Cheshire & the Wirral

Every town has its own page, written around the stacks that are actually on the roofs there. Start with the main chimney repairs page.

Customer Reviews

What Our Customers Say

5.0
★★★★★
74 Google reviews
★★★★★

“Excellent work replacing ridge tiles, repointing chimney and repairing flashing. Also fixed other broken tiles. Clean and tidy job. Would definitely recommend.”

Neil
★★★★★

“The guys did a great job in repairing our chimney. They were reliable, friendly and efficient. Buddy kept me in the loop throughout the whole process and I would not hesitate to use Roofline again!”

Hollie Furnival
★★★★★

“Highly recommend. Very quick and efficient. Great communication. Went above and beyond to work the weekend to complete the work that needed to be done. Very happy with the results.”

Karen Jones

Leave Roofline Solutions a Google review →

Free Quotation

Tell Us About the Chimney

Describe what you can see and roughly where you are, and we will come back to you — usually the same day. If water is coming in now, please call instead.

Prefer to talk? Call 07464 259566 · WhatsApp 0044 7464 259566 · Email Evensbuddy@yahoo.com

Find Us

Roofline Solutions, Elton, Chester

We cover Chester, Cheshire, the Wirral and Flintshire from Elton, just north of Chester.

Where We Are

2 Manley View
Elton
Chester
CH2 4QF

Almost all of our work happens at your property rather than here, so please call before travelling.

Opening Hours

Monday – Friday — 24hrs — Emergency Call-Outs
Saturday — 8:00 – 19:00
Sunday — 8:00 – 19:00

Weekday emergency call-outs are answered around the clock. Weekend cover is 8:00 to 19:00.